eControls, 26072 Merit Circle #110, Laguna Hills, CA 92653 Ph (949) 916-0945 Fax (949) 458-8502
Copyright (C) 2013 eControls, Inc. - All Rights Reserved
Resources
Installer Guide
Product Flyer
The TS02 can be used to monitor supply (discharge) air temperature or return air temperature. It uses a 10k ohm NTC thermistor sealed in the end of a 6-inch stainless steel tube that protrudes into the plenum or duct. Rubber gasket and hardware is included.
The TS03 can be used to monitor outdoor air temperature. It uses a 10k ohm NTC thermistor sealed in the cover.

The cover can be removed for installation and connecting the two sensor wires to a thermostat cable using wire nuts.
Submittal Sheet
The PS01 is used to monitor the duct pressure when using non-calling zone dampers for bypass. The pressure is read and displayed at the panel and if the duct pressure exceeds the limit, the non-calling zone dampers open just enough to keep the pressure within the limit.
Resources
Installer Guide
Product Flyer
Submittal Sheet
Resources
Installer Guide
Product Flyer
Submittal Sheet
PS01 - Duct Pressure Sensor
TS02 - Discharge Air Temperature Sensor
TS03 - Outdoor Temperature Sensor
All iZone Zoning Panels
Compatible iZone Panels
All iZone Zoning Panels
Compatible iZone Panels
All iZone Zoning Panels
Compatible iZone Panels
SW01 - Vacant/Occupied Wall Switch
The SW01 is used to select the vacant or occupied operating mode and connects to the panel.
iWD3P
Compatible iZone Panels
Resources
Submittal Sheet
The PDMi2 has an 18-inch cable that plugs into any iZone zoning panel. It can be used to clone a panel, program the options, display the status of the panel, HVAC system, thermostats, dampers and sensors. the PDMi2 can also be used to test an installation.
All iZone Zoning Panels
Compatible iZone Panels
PDMi2 - Programming and Display Module
Model PIC25
Plug and Play, 25-Foot Cable
Model PIC50
Plug and Play, 50-Foot Cable
Plug and Play Cables with Inline Coupler
The PIC50 is a 50-foot plug and play cable that can be used to replace the 25-foot cable supplied with each play and play damper or extend the 25-foot cable furnished with each plug and play damper to 75 feet using the cable and inline coupler.
Make sure you're viewing the latest version of our website by clicking the refresh button on your navigation bar.